Having the correct moisture levels in silica (silicon dioxide) mixtures has become a critical component during the various stages of glass production.

The silica (silicon dioxide) mixtures can easily become either too wet or dry wasting manufacturer’s time and money as well as impacting the quality of the end product.

With the help of industry partners and more than 30 years of knowledge and experience, your MoistTech staff has developed the IR-3000 Glass Moisture Sensor that is ideally suited to measure the moisture levels in the glass making process. 
 
 

Installation….

The IR-3000 Glass Moisture Sensor should be mounted several inches above the conveyor, before and after the dryer will allow the user to continuously monitor the process and can control the glass moisture content either manually or automatically in the glass making process.
 

Environment….

If the IR-3000 Glass Moisture Sensor has to be installed close to the dryer outlet where it will be susceptible to extreme heat conditions, it is necessary to cool the sensor with either air or water.
 

Benefits….

improved product quality lower energy costs reduced start-up times less waste 100% product inspection less downtime

Your professional MoistTech staff is very experienced with the requirements in the production of the glass making process.  Our sensor calibrations, measurement wavelengths, algorithms and sensor optical requirements are pre-set at the factory.  Typical accuracy is about ±0.1% moisture.  Typical analog range is 1-10% moisture.  The outputs can be adjusted to optimize PLC or recording requirements.