Highlight
50% REDUCTION
in setup time through real-time adhesive coat weight monitoring, eliminating the need for laboratory verification during setup.
Lab testing is no longer required to verify coat weights during setup, cutting time in half!
The Challenge
A packaging manufacturer applying water-based adhesives to various substrates relied on calculating adhesive coat weight after production using material consumption and substrate surface area.
This approach provided only an average across the entire run, making it difficult to identify missing or uneven coatings. Previous attempts to improve measurement using redundant consumption-monitoring systems created additional confusion.
The Solution
IR3000 Sensor
A MoistTech IR3000 sensor was installed immediately after the adhesive coating process and paired with a programmable linear slide.
The system provides real-time coat weight measurements across the substrate width, allowing operators to identify coating inconsistencies and make corrections earlier in production.
The Results
50% Faster Setup: Reduced the need for laboratory coat weight verification which reduced the start up times by 50%!
Earlier Defect Detection: Missing or uneven adhesive coatings can be identified during processing.
Substantially Reduced Waste: Earlier corrections help prevent defective coated material from continuing through production
Better Measurement Visibility: Real-time readings across the substrate replace reliance on whole-run averages.




